AEROJET - OPPOSED JET MILL
The Aerojet microniser is an opposed jet mill. These mills are appropriate for the superfine size reduction of a wide range of both soft and hard materials providing product sizes typically in the range of 1 to 80 microns. Combining the principles of Opposed Jet Fluid Energy Milling with the well proven high performance British Rema Aerosplit Classifier within a single unit, enables accurate and controllable product sizes to be achieved with sharp cut off and a typically narrow size distribution. The small AJ100 jet mill system can be supplied with interchangeable components enabling it to be converted into a Minisplit Air Classifier system for the particle size classification of a wide variety of materials.
Product range from 1 to 80 microns.
Range of sizes to handle from 1 Kg/Hr or less up to 2000 Kgs/Hr.
Integral forced vortex classifier provides accurate control of product size with sharp cut-off.
On-stream adjustment of product size by variable speed classifier rotor.
Generation of superfines controlled by adjustment of jet velocity.
Feed entry configuration allows pre-classification of product sized material prior to milling.
Suitable for handling abrasive materials with minimum contamination.
Ability to accept some feed stocks up to approx. 3 mm reduces necessity for pre-grinding.
Low operating temperatures enable heat sensitive material to be processed.
Manufactured in Mild steel or Stainless steel.
Low operation noise levels.
Easy access for clean-out and maintenance.
Negative pressure operation within the milling chamber provides dust free operation.
Constructed in Mild steel or Stainless steel with provision for special lining as required.
Complete with automatic control system.
